what is an important benefit for hunters who properly clean and maintain their firearms? This is a topic that many people are looking for. bluevelvetrestaurant.com is a channel providing useful information about learning, life, digital marketing and online courses …. it will help you have an overview and solid multi-faceted knowledge . Today, bluevelvetrestaurant.com would like to introduce to you Cleaning your firearms. Following along are instructions in the video below:
To ssaa tv. Your rifle pistol or shotgun. Requires constant maintenance to keep it functioning functioning properly just like any piece of precision equipment starting on the outside all metal should be cleaned and lubricated to prevent rust and corrosion from dirty sweaty fingers mud and moisture metal to metal surfaces need to be cleaned and lubricated to prevent wear the parts that need attention on a bolt action rifle.
Are the barrel. The action bolt and the magazine. Its easy to forget about the magazine but keeping it clean prevents abrasive dirt from entering the chamber with a cartridge clean the bolt face with a toothbrush and apply oil to all exposed surfaces water can pass into the stock out of sight.
So stripping your firearm to its basic components is something you should do if youve been out in damp conditions. Normally a wipe over with an oil cloth is all thats needed cleaning inside the barrel or bore. The wrong way can do more harm than good bent cleaning rods and poorly made brushes can damage the sharp edges of the rifling throat and crown.
So if the rod or brush is off centre.
It can damage the crown and rifling and have a major influence on accuracy cleaning kits are handy compact and widely available alternatively just buy the components. You need. Theres a wide assortment of cleaning products on the market.
And as a general rule. The more expensive the better first of all a strong straight. One piece rod preferably made of steel or carbon fibre with a ball bearing handle buy the most expensive rod you can afford look after it keep it clean and straight.
And it will give you years of reliable service. Using a bore guide helps keep the rod centred. The bronze brush does all the hard scrubbing work.
A nylon brush makes a good jag to wrap the flannelette around cut the flannelette such as this 4×2 to the correct size for the calibre.
You dont want the patch. Too tight or too loose. The chemicals.
Youll need are a bore solvent. Some good gun oil and some methylated spirits. Occasionally.
You might also need something a bit stronger a wool mop is handy for cleaning and drying. The chamber. This one is a 410 shotgun mop when you find good quality cleaning gear.
Look after it wash brushes in mentholated spirits and store them in plastic bags to keep them clean ideally barrels should get a thorough clean after 30 or 40 shots.
If you can scrub the bore with a dry bronze brush after a day out shooting. It will help prevent the build up of whats called powder glaze that forms from the powder residue left inside the barrel this is best done before the barrel gets cold doing this will make cleaning a lot easier when you get home for a thorough clean put the rifle on an angle. So any excess chemicals and residue run out the end of the barrel and not back into the chamber or magazine scrub the bore with a bronze brush soaked in a bore scrub.
Then follow up with a clean patch repeat. These steps. Until the patch comes out without any discoloration finish off with a light oiling remove any oil.
The next time you go shooting sometimes other material may be left in the bore that this scrubbing doesnt remove for example copper from jacketed bullets tiny fragments of copper get stripped off and can affect accuracy. If allowed to build up soak a patch with a copper solvent and wipe. The bore with it leave it in for 10 minutes or longer to let the chemical do its job then wipe it out with a clean patch.
The blue green colouring indicates that there is copper present in the bore repeat these steps.
Until. There is no sign of copper left on the cloth put some methylated spirits on a patch and wipe out any chemical residue. Let the methylated spirits dry out and finish with a light coating of oil mop out the chamber and apply some grease on the metal to metal contact points.
And youre done a bore snake is very useful for cleaning lever and pump action firearms. But this only gives a superficial clean for a proper clean. It has to be done from the muzzle end otherwise the process is the same to prevent powder residue and chemicals ending up in the action and magazine simply turn the firearm upside down in the rest.
Remember. This video is about maintaining firearms that are in good condition to start with no amount of cleaning will bring a worn out barrel back to life. I hope this video has shown that cleaning is something you should do often to protect your valuable investment.
So you can continue to enjoy your sport thanks for watching ssaa tv. And ill see you next time .
Thank you for watching all the articles on the topic Cleaning your firearms. All shares of bluevelvetrestaurant.com are very good. We hope you are satisfied with the article. For any questions, please leave a comment below. Hopefully you guys support our website even more.