schwinn training wheels This is a topic that many people are looking for. bluevelvetrestaurant.com is a channel providing useful information about learning, life, digital marketing and online courses …. it will help you have an overview and solid multi-faceted knowledge . Today, bluevelvetrestaurant.com would like to introduce to you Attaching Schwinn Training Wheels to a 16″ Bicycle. Following along are instructions in the video below:
“Video is going to demonstrate how to install the schwinn training wheels on a 16 16 inch bike. You should have in your package. Two wheels two brackets here. And re gonna have two bolts to lock nuts.
Two spacers to stabilize brackets and four washers. So following..
The instructions here. I m going to take one screw put it through the wheel washer through put it through the bottom end of this bracket. That s gonna be the side here with only one hole no their washer on it and then seal it with lock nut so i ve hand tightened. It now i m gonna use my wrenches to tighten it better nice and tight wheel spins nicely it doesn t wobble too much there now we re gonna repeat that with the next with next wheel bolt through the tyre washer bracket washer lock nut and tighten.
It and then again. I m gonna use my two wrenches here to tighten..
It there we go nice and tight not too wobbly and it spins nicely on the bike itself we re gonna remove the rear axle assembly. I already did this so it s gonna be a lot looser on my side here yeah. It does tend to loosen it so just remove whatever stuff. I ve already got on here.
I m gonna leave that nut though so here the instructions say that we want to put on spacer not stabilizer bracket. Where it should be pointing towards the notch point towards the front of the bike..
Then the wheel bracket and we wanna in this case. I m going to use the small little lowest hole. Because we want to have a little bit of clearance. So this the wheel itself let s go shot of that we want the wheel to kind of be above the ground and if i hold the bike straight.
This is as best as i m gonna get it i can t get it any any higher than this so if everything here in place. I m gonna put the original hardware back on all right..
We re gonna do the same thing now on the other side facer stabilizer with knotch pointing towards the front oops in the lowest hole. We look at it we have some space not much but a little bit of space that you can ride on the main wheels. If you figure it out how it works. I also need to get these tires up to 40 psi oops.
So let s do that now there you go there you go you re doing it you got it ” ..
Thank you for watching all the articles on the topic Attaching Schwinn Training Wheels to a 16″ Bicycle. All shares of bluevelvetrestaurant.com are very good. We hope you are satisfied with the article. For any questions, please leave a comment below. Hopefully you guys support our website even more.
description:
tags:
