laserjet pro 200 toners This is a topic that many people are looking for. bluevelvetrestaurant.com is a channel providing useful information about learning, life, digital marketing and online courses …. it will help you have an overview and solid multi-faceted knowledge . Today, bluevelvetrestaurant.com would like to introduce to you HP CP1215 CP2025 Pro 200/300 Toner Cartridge Refill Instructions. Following along are instructions in the video below:
“Removing the two screws from the nside end cap on the other side remove. These these two nscrews remove the end caps. Be carefull the two halves will start to and the drum will come loose start with the waste chamber. Remove the drum.
It s better to replace it nbut. If you want to reuse the drum lay it in a dark and safe place remove the charge roller make attention not to damage. The nrecovery blade or the cartridge may lose toner on the paper clean. The charge roller with a soft cloth and water take.
The toner section. Remove the screw on the contact side end ncap remove the white contact side end cap slide. The developer roller and remove it remove the gear gently clean the developer roller with isopropyl alcohol. Remove the two screws of the doctor blade remove the doctor blade remove the white felt seal clean out all the waste toner from the ntoner chamber.
And from the toner section. It would be really better if you can use compressed air or a toner vacuum. If not clean the cartridge as well as possible at open air do not breathe the toner dust. If you use compressed air make attention not to damage.
The foam roller inside the cartridge at this point you can fill the cartridge with specific toner do not mix different types of toner make attention in the starter cartridges. The waste hopper and the toner hopper may be smaller clean. The edge of the developer roller blade make attention not to damage or bend. It clean the drum with isopropyl alcohol be careful it s really delicate and it is easy to damage it even the light may damage the drum avoid exposing it to direct sunlight or bright light for more than 10 minutes clean.
The contact on the contact end cap with a cotton swab and alcohol. Install the white felt seal on the feed roller shaft install the doctor blade. The two screws insert the gear in its position. Install.
The developer roller with its ntwo bushings replace the contact end cap and its screws. It s important to gap. The doctor blade properly the doctor blade controls the amount of toner on the developer roller. The gap.
Size is critical to provide quality images and avoid backgrounding or light prints. Install the charge roller coat. The drum with a specific lubricant or with a bit of toner or the wiper blade of the cartridge may damage. The drum install the drum on the waste hopper hold the 2 parts of the cartridge togheter install the 2 side end caps.
This is the correct position of the spring remove the old chip install the new chip. If the new chip is loose in its slot close off the top edges with small amounts of glue. It s not possible to reset. The original chip reinstall.
The four screws on the side end caps. ” ..
Thank you for watching all the articles on the topic HP CP1215 CP2025 Pro 200/300 Toner Cartridge Refill Instructions. All shares of bluevelvetrestaurant.com are very good. We hope you are satisfied with the article. For any questions, please leave a comment below. Hopefully you guys support our website even more.