furr out This is a topic that many people are looking for. bluevelvetrestaurant.com is a channel providing useful information about learning, life, digital marketing and online courses …. it will help you have an overview and solid multi-faceted knowledge . Today, bluevelvetrestaurant.com would like to introduce to you Furring walls 2018-12-29. Following along are instructions in the video below:
” s saturday december 29th got a lot of stuff to do today. We ll see see how much i can get through. But here s the work plan first item to pull this center post out of this closet opening. We re going to go with triple sliding doors here.
So we don t need this post. The part of that work involves fixing up this structure. Now this is not a load bearing wall. But you can see we ve got these verticals that extend right up into that that ledge so i have to cut those out.
And i ll show you when i m done what i did to to put it back together okay item number two this outlet needs to move over about 10 inches. So we ll have a mirror. There so that s got to move over shouldn t be a big deal number three i have to fuhrer out this last little section of wall here take it up close and you can see the existing walls got an inch and a half furring on it and that s because this wall carries a four inch waistline so since i extended that wall and you defer out the section and number four. We got to fur out this entire wall.
The reason is again related to a four inch sewer line. This one sticks out just a little proud of that wall so i ll have to see if i can get away with one inch or i have to go to full inch and a half working on that today job. One is done center post is gone. And that s how the structure was replaced irani 2×4 across the whole span.
It s about 37 inches patched in the little hole. There and then just put the studs back in alright job. Number two is done receptacle is moved and i patched up the hole. Where the old one was and while i was in the panting mood.
We had a few other spots where this is some of the rare remaining original sheetrock in the house. There s only a couple of walls with it there. But we had been a little careless and punched a hole. So i patched that there was a hole.
I pushed in here because i had fed a wire down earlier for my coax that i couldn t remember where it was still fixed that and then last. One was an old receptacle that was at floor level back. When this was a hallway now that it s a stairway. We don t want to receptacle there.
So i patched that right jab number three done inch and a half sham onto this little short section of wall right down to the floor and jab for done shem down an inch. All the way around you know it looks just like it started. But we ve got an actual inch and a half extra and i ll show you why we needed to do this. This is where the sheetrock goes you can now see we get clearance to get around that pipe and by the way.
That s not a four inch pipe. That s a three inch pipe. So that s it i actually got a lot done today. I didn t expect to finish everything.
But this is all done so now i can go out and plow snow see you next ” ..
Thank you for watching all the articles on the topic Furring walls 2018-12-29. All shares of bluevelvetrestaurant.com are very good. We hope you are satisfied with the article. For any questions, please leave a comment below. Hopefully you guys support our website even more.